Power Republic RSS

Go-Karts, Karting, Power Republic, YouTube -

The karting world is constantly changing, and now with the information super highway flowing at full speed, karting knowledge has grown and is now spreading like wildfire.

Read more

Axle, Axle basher, Axle Removing Tool, Go Kart Axle, Go Karts, Gold Coast, Karting, OTK, Power Republic, Removing Axle -

Want to remove your go kart axles with ease? Introducing the Power Republic Axle Removing Tool.  This is an essential item for any karters tool box and takes all of the hassle out of removing and changing axles on the go.

Read more

Castor Kits, Go Karts, KartShop Castor Kit, OTK Castor Pills, Power Republic -

Custom tune your front end setup down to the last detail  with the new Castor Kits from our friends at Kartshop.com!

Read more

Engineering, Go-Kart Shop Gold Coast, Go-Karts, Gold Coast, Kart Shop, Karting, Knowledge Is Power, OTK, Power Republic, Tony Kart, Tony Kart Australia, YouTube -

In a recent YouTube video, we took you through the steps to fitting your own go kart seat. There are many ways to fit a seat to a go kart, however, after years of putting each method to the test, we have found this procedure to be the easiest and most efficient, leaving you with plenty of time to concentrate on your race preparation. Below we take you through the steps in a little more detail: Tools Required for this process are: Battery drill Tape measure Bullet point marker pen (e.g Sharpie) 2 x 5mm Allen keys (1 T-Bar and...

Read more

Engineering, Go-Kart Shop Gold Coast, Go-Karts, Gold Coast, Kart Shop, Karting, Knowledge Is Power, Power Republic, Rotax, Rotax Max 125, Tony Kart, Tony Kart Australia, YouTube -

  This post takes you through the steps to change the front sprocket of your Rotax Max 125 engine and how to remove and re-install your clutch drum. Once you notice that your front sprocket is worn, it's a good idea to change your front and rear sprocket and chain at the same time, as they will usually wear at the same rate. Tools required for this job are: Torque wrench able to do 110Nm (optional)Breaker bar16mm or 17mm ring spanner5mm allen key38mm impact socket17mm impact socket (optional)5mm in-hex socket (optional)Rotax sprocket holder & locking tool for ring gear  ...

Read more